Mounting and dismounting of tires

Tyres are the vital link in the car, which connects the vehicle and the road. In this regard, it is very important to properly and timely apply to the replacement of tires and keep them in good condition. Best of all mounting and dismounting tires hold on service stations. Replacing tires - is one of the essential points of maintenance car. Therefore, in the assembly and disassembly of tires to use proper equipment. The use of such equipment requires special skills. Before mounting or dismounting tires, it is important to make measurements of tires and their load index and speed, since improper installation can lead to irreparable consequences such as damage to the tires or worse, break the tire, which can lead to accidents. In this connection, it is recommended to all car enthusiasts first consult with professionals, or provide installation or dismantling of dedicated service stations. There is only one excludes the case where removal is not appropriate tire dimensions. This may be an urgent replacement spare wheel. This tire is technically sound and only a very short time to get to your destination. In order to mount a tire on the rim should be read carefully labeled DOT, which is located on the bus in the area of ??the board. This marking should be on the outside of the tire. If you are mounting tubeless tires, it is only possible on specially designed for this car with built-in flat Hamp. The tubeless tires are mounted by means of the valve with a sealing gasket, which should match the size of the rim. Each time when mounting tubeless tires used only the new valve. Good adhesion of tires to the board can be achieved by simple way. To do this, pump the tires up to 3.5 bar, and then bring up the level of pressure needed. Internal pressure of the tire has its own parameters, and ignoring them is dangerous for buses. If the level of tire pressure is insufficient, it can lead to overheating of the tire, and in consequence, and to leave them out of order.